The
NEW and inoovative MTMK2 Series range of power amplifiers now comes with LCD display and password protection from Proton are what every
text book amplifier in the pro-audio industry should be. If
one is to look at the desirable aspects of these qualities
then it is very simple. These qualities are maximum reliability,
minimum maintenance, high power to weight ratio, flexibility,
efficiency, thermal control and of course sound quality. MT
series use innovative methods in "Circuit breaker" technologies for the power supplies, and also the auto cutoff
which will switch ON, in the rare case high DC current abnormalities,
protecting both, the amplifiers and the loudspeaker from damage.
The heavily protected chassis is quite "bombproof" in construction ensuring minimum physical damage. |
- LCD SCREEN DISPLAY Overload Protect: SHORT CIR PROT, OVERLOAD & FAULT DC PROT FAULT
- Active Clip Limiting : At the amplifier's full power limit, or clipping point, LX tm will be activated. This is indicated by illumination of the limiter LED. The channel gain is automatically reduced, protecting the loudspeakers from potential damage from the high power, continuous square waves that would otherwise be produced. LX TM may be activated by uncontrolled feedback, oscillations, improper equipment gain settings, or an equipment malfunction upstream from the amplifier. Only steady or excessive clipping (not normal program transients) will trigger LX TM. The circuit is virtually transparent in operation and full signal bandwidth is maintained.
- IGM Impedance Sensing : IGM (Instantaneous Gain Modulation) is an innovative circuit that allows the amplifier to operate safely into difficult loads. When the amplifier sees a load that overstresses the output stage, the IGM circuit adjusts the channel gain to a safe level. Like LX TM , the IGM circuit is inaudible in normal use, In addition, if extreme and sustained low impedance is encountered, the amplifier's output relay will open.
- Auto Ramp operates every time the amplifier is turned on or is reactivated after a protect condition is corrected. This exclusive PROTON by Nx Audio feature gradually increases gain to the attenuator setting avoiding unnecessary stress on the loudspeakers.
- LRS TM Short Circuit Protection : If an output is shorted (i.e., defective speakers or crossed speaker wires) the LRS TM will automatically Protect the amplifier. The LRS TM circuit senses the short circuit as an extremely stressful load condition and attenuates the signal, protecting the channel's output transistors from over-current stress. The load will be disconnected by the thermal protection circuitry (output relay Opens).And the amplifier will be shut down, please remove the short circuit and switch on the amplifier again to restart the amplifier.
- Subsonic Frequencies : Built- in high pass filtering provides subsonic frequency protection for each channel. In addition, a relay will open if excessive subsonic energy appears at the output. .
- Stable
performance / precise workmanship.
- Low
power consumption less than 0.1A when working without load &
Zero noise.
- High-efficient
APS circuit for best power supply.
- Perfect
limiter circuit protects your loudspeakers.
- 2
cooling fans controlled by temperature.
- Equipped
with Rubycon capacitors
- Built-in
High Pass & Low Pass Crossover
- Specialized
system protection circuit,
comprehensive, safe, reliable and accurate such as Short circuit
protect, Over load protect, DC protect, (inrush audio peak)
Limiter Soft start, High Temp protect, HF protect, Back-EMF
protect etc.
- Stereo
/ Parallel / Bridge Modes
|
|
|
